AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |
Back to Blog
Lynteck nexus 8 user manual3/10/2023 The panel's tamper switch has been linked out with soldered jumpers and I don't know if you need the tamper open to default the codes. I tried to default the codes, as per the manual, but this didn't seem to work either. Entering the code(s) makes the RKP beep but no change to the display. Yes, I put Power On and, no, there are no 2, 3, 4 RKPs (and never were.). The Nexus 8 alarm panel base is moulded such that it stands 5mm clear of. When I power it up, the 7-segment display shows Po, r2, r3, r4 in a cycle. I haven't seen one of these before so I'm not sure if I'm missing something or it's knackered. The circumstances of the last moments of the panel, before it was removed and sent to me, could include power problems so it might just be dead. The panel has had a hard life at the hands of an amateur and I'm not sure if I have the right codes. I've been given a Nexus 8 panel to see if I can get anything out of the log (such as it is.).
0 Comments
Read More
Leave a Reply. |